top of page

WORKSHOP PROJECTS

Workshop Projects

McDonald Bros Racing have been building or modifying street rods, street machines and drag vehicles for 40 years and with our vast experience we can offer you any type of modification imaginable to your project.
 

Services available through our workshop include:

Chassis clips from bare frame to full competition, installation, Roll bars & cages, Mini tubs to full tubs, New diff fabrication and modifications, Chassis reinforcing, speciality suspension modifications & fabrications, Disc brake conversion, Specialty fabrication.

Installing Coil Over Shockers in HQ-WB Holden

To install vertically mounted QA1 over shocks requires removing the original upper crossmember from the chassis rails, creating clearance of the floor panel to install the units and reinforcing the chassis rails before installing the crossmember and bracketry. Adjustable upper and lower trailing arms were also installed for maximum adjustability.
(Click on image to make larger)

1969 Camaro Suspension Mods

This Camaro was bead blasted and found to be not in very good condition. We had to fabricate new rear chassis rails and set them in to be able to fit the 20 x 10 rims and set the vehicle up to sit very low. As we were designing a bolt in tri 4 link QA1 coil over kit for this range of Camaros we incorporated it into this vehicle. The diff is a new heavy duty housing and 35 spline floater, the brakes will be 330 mm units.

ADDRESS

6/196 Settlement Road

Thomastown. 3074. Victoria

Australia

​

+61 3 9465 0000

SUBSCRIBE FOR EMAILS

Thanks for submitting!

© 2020 McDonald Bros Racing Products.

Site by Bounce Interactive

Terms and Conditions

bottom of page